This will help ensure you do not strain the wires. Use the 2.5mm hex key to remove the screw holding the part cooling fan in place and then carefully twist the fan upwards as you remove it. You should also place a cloth or piece of fabric over your heat bed to give it some protection in case you drop something onto it.ġ. You should also ensure there is no filament loaded and that the printer is unplugged from the power source before starting. Move your extruder to roughly the centre of your bed and around 100mm above the build plate before starting this upgrade, this will give you easier access to the extruder.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |